Install The Rear Panel On The Wall - Sanyo KS1852 Installation Instructions Manual

(4) Using a sabre saw, key hole saw or hole-cutting drill
attachment, cut a hole in the wall. See Table 4 and
Fig. 10.
Table 4
Hole Dia.
2-9/16" (65 mm) / 3-5/32" (80 mm)
(5) Measure the thickness of the wall from the inside
edge to the outside edge and cut PVC pipe at a
slight angle 0.25 in. (6 mm) shorter than the thick-
ness of the wall. (Fig. 11)
(6) Place the plastic cover (locally purchased) over the
end of the pipe (for indoor side only) and insert the
pipe in the wall. (Fig. 12)

3-3. Install the Rear Panel on the Wall

Be sure to confirm that the wall is strong enough to sus-
pend the unit.
See either Item a) or b) below depending on the wall type.
a) If Wooden Wall
(1) Attach the rear panel to the wall with the 10 screws
provided. (Fig. 13)
If you are not able to line up the holes in the rear
panel with the beam locations marked on the wall,
use rawl plugs or toggle bolts to go through the
holes on the panel or drill 3/16 in. (5 mm) dia. holes
in the panel over the stud locations and then mount
the rear panel.
(2) Double check with a ruler or carpenter's level that
the panel is level. This is important to install the unit
properly. (Fig. 14)
(3) Make sure the panel is flush against the wall. Any
space between the wall and unit will cause noise
and vibration.
b) If Block, Brick, Concrete or Similar Type Wall
Make 3/16 in. (4.8 mm) dia. holes in the wall. Insert
rawl plugs for appropriate mounting screws. (Fig. 15)
NOTE
Hole should be made at a slight downward slant to the
outdoor side.
PVC pipe (locally purchased)
INSIDE
Plastic
cover
7
Indoor Outdoor
side side
Fig. 10
Cut at slight angle
Fig. 11
OUTSIDE
Wall
PVC pipe
Slight
angle
Fig. 12
Fig. 13
Fig. 14
3/16" (4.8 mm)
dia. hole
Rawl plug
Fig. 15