Leadtek Quadro Series Manual page 13

Hardware Installation Hardware Installation
4
Step
Fasten the mounting bracket to the chassis.
5
(Only for Quadro FX3000/3000G/2000/1100/1000 and other new
Step
products with the 4-pin connector)
NVIDIA
Quadro
6
Plug the cord into the matched connector of the
Step
graphic card according to what kind of monitor
you have.
7
Reconnect all the cables and cords.
Step
A Note for the Fan
If the heat dissipation device provided is a fan, it
is subject to damage if not properly handled. It is
important not to put pressure on the axle or
handle the fan by the axle. A shifted axle may
shorten the fan's lifespan.
Before Installing the Driver
The product package contains the Software
Pack CD. Please read the Readme.txt file for
the latest information about the software before
proceeding with the driver installation.
4-pin connector
If the card has a 4-pin power connector located at
the edge of the board, as shown in the diagram left,
please use the included power cable, as shown to
the right, to connect the system power supply and
the 4-pin connector on the video card.
If your computer has an unused power cable you may
connect it to the product directly.
Leadtek Quadro Series General Guide
Do not handle the
fan by the axle.
11