Korg m3 Operation Manual page 154

Note: The contents and settings of the dialog box will
differ depending on the type of file that you are
loading.
3. Check the "Load ********.PCG too" check box.
When you execute loading, the .PCG file will be loaded
along with the .SNG file.
Check the "Load ********.KSC too" check box.
When you execute loading, the .KSC file will be loaded
along with the .SNG file.
Use ".PCG Contents" to specify the data that you want
to load.
If you want to load all the data in the .PCG file, select
All.
Use "Select .SNG Allocation" to specify the destination
to which the song data will be loaded.
"Append" will load the song into the song number
that follows the song(s) currently existing in internal
memory, without leaving a vacant number.
"Clear" will erase all songs from internal memory, and
load the songs into the numbers from which they were
saved.
Use "Select .KSC Allocation" to specify where the
multisamples and samples will be loaded.
"Append" will load the data into the next available
vacant numbers following the multisamples and
samples that are already in sample memory (RAM).
"Clear" will erase all multisamples and samples from
sample memory (RAM), and load the data in the same
configuration with which it was saved.
4. Press the OK button to execute loading.
Never remove the media while data is being
loaded.
Loading M3 system update data
You can update the M3's system by downloading the
most recent version of the system file from the Korg
website (http://www.korg.com) to your computer,
and loading it into the M3. For details on the
procedure, refer to the Korg website and to "Update
System Software" on page 400 of the Parameter Guide.
Use the Global mode menu command Update System
Software to load the system update data.
Loading data Loading data from media (Media–Load)
147