Audio Control; Audio Control Menu - Kenwood DNX520VBT Instruction Manual

Audio Control

Audio Control Menu

Displays the Audio Control menu to set the sound
effect function of this unit.
1 Display the Source Select Screen
SRC
2 Display the Audio Control menu
In this manual, the above selection is indicated
as:
>
Touch [ ] [
3 Select the Audio Control item
Item
[Audio Control]
[Equalizer]
[Tone]
[Zone Control]
54 DNX520VBT
].
Page
54
55
55
56
Audio Control
You can adjust the front/rear and right/left audio
balance.
1 Display the Audio Control screen
> >
Touch [ ] [ ]
2 Set each item
1 1 1
1 Adjusts the front/back and left/right balance
of the volume by touching the Adjust screen.
[2], [3] Adjusts the right and left volume
balance.
[5], [∞] Adjusts the front and rear volume
balance.
[VOL.Offset] Finely adjust the volume of the
current source to minimize the difference in
volume between different sources.
⁄
• If you have increased the volume first, then reduced
the volume using the "VOL. Offset", the sound
generated if you suddenly switch to another source
may be extremely loud.
[Subwoofer Level] Adjusts the subwoofer
volume.
The setting is available when subwoofer is set
to "ON". See <Speaker Setup> (page 71).
[Loudness] Turns the loudness control
function On or Off.
If turned "ON", high and low tones are
automatically enhanced during low volume.
Settable only when zone function is set to Off.
See <Zone Control> (page 56).
[Stream Information] Displays the present
source information.
The stream (Dolby Digital, dts, Linear PCM,
MPEG, MP3, WMA or AAC) is displayed.
[Audio Control]. (page 54)