Table of Contents
Advertisement
2 - 13 Presser Foot Height
Checking:
1. Lower feed dog below the needle plate.
2. Lift up presser foot lever.
3. Check and see if clearance (A) between needle plate and presser foot is
about 5.5 mm.
Adjustment:
1. Remove face cover.
2. Loosen screw (2) of presser bar clamp (1) and adjust the height by verti-
cally sliding presser bar (3).
3. Tighten screw (2) securely after adjustment, keeping alignment of the foot
against feed dog.
SECTION
2 - 13
PAGE
1
Advertisement
Table of Contents
