Table of Contents
Advertisement
2 - 9 "0" - Feeding Needle Positioning
Checking:
1 Set stitch length control at "0", and selector dial at "Straight Stitching A".
2. Place paper under presser foot and take 11 stitches without thread.
3. Deviation of all stitches must be within 0.6 mm in forward direction (about
2/3 of needle thickness).
Adjustment:
1. Inserting the plus screw driver through the hole and adjust the screw inside
of the machine.
Fig. a ) ð Turn anti-clockwise.
Fig. d ) ð Turn clockwise.
SECTION
2 - 9
PAGE
1
Advertisement
Table of Contents
