JUKI ACF-172-1790 Instruction Manual page 26

When the switch is pressed, the following series of operation will be performed automatically
[Series of the operation for men's wear]
Start
The preset board moves forward and
feeds the material on the carriage.
Stacking
The conveyer returns to its
home position
[Series of operation for ladies' wear]
Start
The preset board moves forward and
feeds the material on the carriage.
Stacking The conveyer returns to its
home position
For the operating procedure of start and workpiece suction, operate in accordance with the type selected in
"Start switch selection" of the memory switch data
[Operating the A-mode (the knee switch is used to start sewing)]
1) Press READY key
green)
2) Properly se the material on the preset board. (See the figure below.)
3) When knee switch 3 is pressed, the material will be sucked (workpiece suction lamp 5 lights up). When
it released, the machine will start running.
* When the material is sucked (workpiece suction lamp 5 lights up), press hand switch 4 and the workpiece
suction mechanism is released (workpiece suction lamp 5 goes off). Then the start is released.
* If you repeat steps 2) and 3) during sewing the 1st workpiece, continuous operation can be performed.
[Operating the B-mode (the hands switch used to start sewing)]
1) Press READY key
green)
2) Properly set the material on the preset board. (See the figure below.)
3) When hand switch 4 is pressed, the material will be sucked (workpiece suction lamp 5 lights up).
When it released, the machine will start running (workpiece suction lamp 5 goes off).
* When the material is sucked (workpiece suction lamp 5 lights up), press knee switch $3$ and the
workpiece suction mechanism is released (workpiece suction lamp 5 goes off). Then the start is released.
* If you repeat steps 2) and 3) during sewing the 1st workpiece, continuous operation can be performed.
The proper material setting
1) Men's shirts
Place the material so that there is no clearance
between the side end of the material and
presetting board A, and align the top end of
the material witch marker B.
2) Ladies' shirts
Place the material so that there is no clearance
between the side end of the material and
presetting board A, and align the top end of
the material with maker C.
Buttonhole
sewing
Buttonhole
sewing
on the operation panel to make the ready ON state.(State that the screen is
on the operation panel to make the ready ON state.(State that the screen is
Buttonhole Index in the right direction
sewing (the carriage moves)
Index in the
right direction
The carriage travels to its
rightmost position
Index in the
right direction
.
A Side end of the
material
Men's shirts
C Top end of
the material
Ladies' shirts
23
Buttonhole
sewing
Index in the left direction
(the carriage move)
Buttonhole
sewing
Top end of the
B
material
Side end of
A
the material