Jet JMS-10SCMS Benchtop Series Operating Instructions And Parts Manual page 25

Bevel/Miter Settings
Settings for standard crown molding lying flat on
compound miter saw table.
Note: The chart below references a compound cut
for crown molding only when the angle between the
walls equals 90°.
Type of Cut Key
Inside corner – Left IL
Side
Inside corner – IR
Right Side
Outside corner – OL
Left Side
Outside corner – OR
Right Side
Bevel Miter
Setting Setting
33.9° 31.6°
Right
33.9° 31.6° Left
33.9° 31.6° Left
33.9° 31.6°
Right
25
Procedure
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. LEFT side is finished piece.
1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. LEFT side is finished piece.
1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. RIGHT side is finished piece.
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. RIGHT side is finished piece