Jet JMS-10SCMS Benchtop Series Operating Instructions And Parts Manual page 18

Note: The quick-cam miter table lock should lock
the table and prevent it from moving. If adjustment
is needed, see Quick-cam Miter Table Lock
Adjustment below.
Quick-cam Miter Table Lock Adjustment
Referring to Figure 19:
1. Place the quick-cam miter lock (A) in the down
position to lock.
2. Loosen the lock nut (D) with a 13 mm wrench,
then turn the stop nut (E) to extend the locking
arm against the base of the miter saw.
3. Test the quick-cam miter lock (A) to verify that
it locks the table securely into position.
4. Tighten the lock nut (D) to lock the miter
locking mechanism into place.
Presetting the Cutting Depth
The depth of cut can be preset for even and
repetitive shallow cuts.
Referring to Figure 20:
1. Pull hold-down latch (C) out.
2. Flip the stop plate (A) counterclockwise to the left.
3. Adjust the cutting head down (See Cutting
Head section) until the teeth of the blade are at
the desired depth.
4. While maintaining the cutting head in the
desired position, turn the stop knob (B) until it
touches the stop plate (A).
5. Recheck the blade depth by moving the cutting
head front to back through the full motion of a
typical cut along the control arm.
Rear Support Bar
Do not operate the saw without
the rear extension support bar. Failure to comply
may result in serious injury!
Loosen the two screws (A, Fig. 21) and extend the
rear extension support bar (B, Fig. 21) by sliding it
out, then tighten the two screws.
Laser Beam
The laser is turned on with a switch located on the
saw handle (A, Fig. 22). When left on indefinitely, a
sensor will turn the laser off after 20 minutes. The
switch must be reset (turned off, then turned on
again after 2 seconds) to restart.
The laser has no adjustments and should not
require adjustment. If adjustment should become
necessary, take the miter saw to an approved
Figure 20
Figure 21
Figure 22
18