Operation - Jet JMS-10SCMS Benchtop Series Operating Instructions And Parts Manual

service center.
•
Laser radiation. Avoid direct eye exposure.
Always un-plug miter saw from power
source before making any adjustments.
•
Laser Warning Label: Max output <1mW
DIODE LASER: 522-542nm, Complies with
21CFR 1040.10 and 1040. 11.
Use of controls or adjustments
or performance of procedures other than those
specified in this
hazardous radiation exposure.
The use of optical instruments
with this product will increase eye hazard.
•
Do not attempt to repair or disassemble the
laser. If unqualified persons attempt to
repair this laser product, serious injury may
result. Any repair required on this laser
product should be performed by authorized
service center personnel.

Operation

Before attempting any operation
with your miter saw, make sure that you have
read and thoroughly understand the warnings
contained on pages 4-5 and the Compound
Miter Saw Safety section on page 6. Failure to
comply may result in serious injury!
Starting a cut
1. Place hands at least 8-3/4 in. away from the
path of the blade.
2. Hold workpiece firmly against the fence to
prevent movement toward the blade.
3. Bring the saw blade down to the workpiece to
see the cutting path of the blade.
4. Squeeze the trigger switch (A, Fig. 23) to start
saw.
5. Lower blade into workpiece with a firm
downward motion.
manual may result
Finishing a cut
1. Hold the cutting arm in the down position.
2. Release trigger switch (A, Fig. 23) and wait for
all moving parts to stop before moving your
hands and raising the cutting arm.
3. If the blade does not stop within 10 seconds,
unplug the saw and follow the instructions in
the Troubleshooting section.
If material becomes jammed
1. Release trigger switch.
2. Wait for all moving parts to stop.
3. Unplug the miter saw.
To Turn the Saw On
Depress the trigger switch (A, Fig. 23).
Note: Make the On/Off switch child-proof by
in
inserting a padlock through the hole (B, Fig. 23) in
the trigger switch.
The miter saw is equipped with an automatic blade
brake. When the trigger switch is released, the
electric blade brake will stop the blade within
approximately 10 seconds.
19
Figure 23