Rotating Objects - Janome DigitizerPro Instruction Book

Height scaled
Original
by 150%
object
Note After scaling, the new object size is reset to
100%.

Rotating objects

You can rotate objects directly on-screen or by
using the Rotate tool.
Rotating objects using click and drag
When you select an object, selection handles
display at its extremities. If you click the object
again, the handles change to rotation handles.
To rotate objects using click and drag
1 Select the object/s to rotate.
2 Click the object a second time.
Rotation handles appear at the corners of the object
and an anchor point displays at the object's center.
First click displays Second click displays
selection handles
Note If you click too quickly, the Object Details dialog
opens.
3 If required, drag the rotation anchor from the center to
a new position.
4 Click a rotation handle, and drag it clockwise or
anti-clockwise. An outline and cross-hairs display as
you rotate.
Height scaled by 50%
width scaled by 125%
Rotation handle
Skew handle
Anchor point
rotation handles
JANOME Embroidery Software Instruction Book
Chapter 16 Arranging and Transforming Objects
Drag a corner to Drag the anchor
rotate about the
anchor point
Rotating objects using Rotate CCW/CW
Click Edit > Rotate 45° CCW/CW to rotate a
selected object or design by 45° clockwise.
Right-click to rotate by 45° counter-clockwise.
Use the Rotate 45° CCW/CW tool to rotate
objects by 45° rotations in either direction.
To rotate objects using Rotate CCW/CW
1 Select object/s with the Select tool.
2 Click Rotate 45° CCW/CW on the toolbar.
Click to rotate 45° counter-clockwise.
Right-click to rotate 45° clockwise.
Try this! You can also access the commands via the
Resequence List. See also
objects.
Drag a corner to
point rotate about the
anchor point
Resequencing selected
121