(U) - Deleting All Snmp Community Strings; (E) - Ending Your Session; (Reboot) - Reboot Device; (D) - Enabling Dhcp - IMC Networks iMcV-FiberLinX-II Operation Manual

(U) - Deleting All SNMP Community Strings

To delete all community strings and start over, press U. You will then be prompted,
"Are you sure you want to delete all community strings?" Press Y to proceed, N to
abort. Press Enter to finish.
This function will delete all community strings. If you want to be able to selectively
delete community strings, use iConfig to configure your device.

(E) - Ending Your Session

Ensure you press E to end the session before disconnecting the serial cable. This will
stop the continuous stream of data that is sent to the serial port.
(REBOOT) – Reboot Device
By typing REBOOT, the device will restart, which will result in a temporary loss of
operation of the unit while it re-initializes.
(D) – Enabling DHCP
By pressing D, a screen will appear which will allow you to enable or disable DHCP
for the device. By default, the DHCP client is disabled.
Commands List (Space Bar)
The iMcV-FiberLinX-II also includes several device-specific options. To access these
options, press the Space Bar from the Main Configuration screen, type the name of
the action you want to perform (as shown below) and press Enter.
Command Description
-------- -----------
cleandb Reboot With Cl
download File Download
ifstats Display Port Statistics
rmstats Display Port RMON Stat
version Show Firmwar
reboot Reboot Unit
security Configure Non-Standard Network Se
port Display And Change Por
config Set mode of operation
accounts Add or Delete Username/Pass
sysdescr Change System Descriptions
unit Display And Change Unit Settings
bw Display And Change Bandwidth Settings
->
Press RETURN To Go Back To Main Screen.
Command
cleandb
download
ifstats
ean Database
e Version
Description
Allows Reboot of the unit with a clean database.
Downloads firmware from Server IP address using TFTP.
Displays interface statistics.
istics
ttings
t Settings
word Accounts
21