Table of Contents
Advertisement
Basic Device Configuration
After running through an initial self test, the screen will display the following message:
"Press <Enter> for Device Configuration." Press Enter open the main configuration
screen:
Saved Values. <These values will be active after reboot>
IP Address
Subnet Mask
Default Gateway -
Server IP Addr -
New Prom File
Current Values. <These values are i
IP Address
Subnet Mask
Default Gateway -
Server IP Addr -
New Prom File
Co
mmunity String:
Press
I
to enter new saved parameter values. Press
Press
T
to enter new Trap Destination. Press
Press
C
to enter new Community String. Press
Press
E
to End session. Type
Press
SpaceBar
for additional commands.
This screen contains the following information and options:
Saved and Current Values
Saved values display the changes made during the current session and current values
display the values currently in use:
•
IP Address (IP address of SNMP agent)
•
Subnet Mask (mask to define IP subnet to which agent is connected)
•
Default Gateway (default router for IP traffic outside of the subnet)
•
Server IP Address (TFTP server)
•
New Prom File (TFTP new file name)
Command List
I = Allows you to enter new Saved Parameter Values
P = Allows you to change the Password*
T = Allows you to enter new Trap Destinations
K = Allows you to remove All Trap Destinations
C = Allows you to create SNMP Community Strings
U = Allows you to delete All SNMP Community Strings
E = Allows you to End the session*
REBOOT = Allows you to Reboot the unit (may result in short data loss)
D = Allows you to enable or disable DHCP
Space Bar = Opens the device specific configuration options screen.
-
10.10.10.10
-
255.0.0.0
000.000.000.000
000.000.000.000
-
filename
n use now>
-
10.10.10.
10
-
255.0.0.0
000.000.000.000
000.000.000.000
-
filename
public
Access:
REBOOT
to re
DHCP is not active
r/w
P
to change Password.
K
to remove
U
to remove
boot unit. Press
18
ALL
Trap Destinations.
ALL
Community String
D
for
DHCP
On/Off.
s.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the iMcV-FiberLinX-II and is the answer not in the manual?