HP D7522A 10/100 3Com 3C905C-TX Installation Manual page 15

13 Follow the onscreen instructions, if you are prompted for
14 Enter the location of the Windows NT 4.0 files (CAB files) when
15 When prompted to reboot, remove your driver diskette and click
CAUTION
If a service pack was already installed on the PC before the network
interface card was installed, the service pack must be reinstalled.
This will overcome the At Least One Service Failed to Start error when
Windows NT is started.
On some platforms you also need to reinstall certain drivers after
installing the Service Pack. Refer to your PC documentation for more
information.
Installing the Driver from the Hard Disk (Advanced Users)
To install the network driver in a PC running Windows NT version
4.0 from driver files on the hard disk:
1 Restart the PC and start Windows NT.
2 Create a folder for the drivers, for example, C:\LAN3COM.
3 Insert diskette 1 in your drive and copy the entire contents to
4 Insert diskette 2 in your drive and copy the entire contents to
5 Perform the installation from step 2 onwards of "Installing the
Updating the Driver
If you already have the 3C905C-TX network driver and want to
update it, follow the instructions provided below.
1 Double-click on the My Computer icon, then double-click on the
2 In the Control Panel window, double-click on Network.
3 In the Network window, click on the Adapter tab.
HP 10/100 3Com 3C905C-TX Network Interface Card Installation Guide
network information, enter the information supplied by your MIS
department.
prompted, then click on OK. On HP Windows NT 4.0 preloaded
systems, the path is C:\i386.
on Yes. The driver and network software installation is complete.
your new folder.
your new folder. If you are prompted to overwrite any files click
on Yes.
Driver from the diskettes" on page 14. At step 8, specify the
folder that you copied the files to, for example,
C:\LAN3COM\WINNT.
Control Panel icon.
Software Installation Procedure
English 15