HP D7522A 10/100 3Com 3C905C-TX Installation Manual page 13

1 Double-click on the My Computer icon, then double-click on the
2 Double-click on the System icon. The System Properties box
3 Click on the Device Manager tab. A list of devices appears,
4 Finally, double-click on Network Adapters. The name of the
5 In the Device Manager window, double-click on Other Devices.
6 Click on PCI Ethernet Controller or the duplicate 3C905C-TX NIC
7 Click on Remove.
8 Restart your PC.
Checking the Follow these steps to confirm that your network setting are correct
on a PC running Windows 95 or Windows 98:
Network Settings
1 In the Control Panel window, double-click on the Network icon.
2 Ensure that you have the correct Client and Protocols installed.
3 Finally, double-click on each of your installed protocols and
Software Installation and Update on a Windows NT 4.0
System
Windows NT This section describes how to install the network driver in a PC
running Windows NT version 4.0 without the networking
4.0 Users
components installed.
HP 10/100 3Com 3C905C-TX Network Interface Card Installation Guide
Control Panel icon.
appears.
arranged by type.
installed network interface card appears:
3Com EtherLink 10/100 PCI For Complete PC Management NIC (3C905C-
TX).
If this name does not appear or if a yellow exclamation mark
appears next to it, follow this troubleshooting procedure:
entry.
You may need to contact your MIS manager for this information.
ensure that your settings are correct for your PC's connection to
the LAN. You may need to contact your MIS manager for this
information.
Software Installation Procedure
English 13