Hoshizaki DCM-240BAF Service Manual page 41

GEAR MOTOR
24) Cut the Gear Motor leads at the wire connector.
25) Remove the three Hexagon Bolts securing the Gear Motor on the chassis.
26) Remove the Gear Motor.
27) Install the new Gear Motor.
28) Assemble the removed parts in the reverse order of which they were removed
Be careful not to scratch the surface of the O-ring, or it may cause water
leaks. Handle the Mechanical Seal with care not to scratch nor to
contaminate its contact surface.
29) Check for water leaks.
After assembling the Extruding Head, be sure to check that the Auger does
not come into contact with the inner surface of the Evaporator and that there
is not any abnormal noise from the Bearing.
30) Turn on the power supply.
31) Move the Ice Making Switch to the "ON" position.
A2AAA0269806
WARNING
WARNING
41