Maintenance - Hoshizaki KMD-850MAH Service Manual

3) Pour the sanitizing solution into the water tank.
4) Replace the insulation panel and the front panel in their correct positions.
Note: Make sure that the control switch is in the "WASH" position and the cleaning
valve is open.
5) Turn on the power supply to start the sanitizing process.
6) Turn off the power supply after 15 minutes.
7) Remove the front panel.
8) Remove the insulation panel. Remove cube guide B, then remove cube guide A.
Remove the overflow cap, overflow pipe, and water shield.
9) Remove the drain plug and drain the water tank. Replace the drain plug in its correct
position. Be careful not to cross thread it.
10) Replace the water shield, overflow pipe, overflow cap, cube guide A, cube guide B, and
insulation panel in their correct positions. Be careful not to cross thread the overflow
pipe.
11) Repeat steps 17 through 30 in "1. Cleaning Procedure" two times to rinse thoroughly.
12) Close the cleaning valve.
13) Move the control switch to the "ICE" position.
14) Replace the front panel in its correct position.
15) Clean the storage bin/dispenser unit liner using a neutral cleaner. Rinse thoroughly
after cleaning.
16) Turn on the power supply to start the automatic icemaking process.
B. Maintenance
This icemaker must be maintained individually, referring to the instruction
manual and labels provided with the icemaker.
1. Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean, soft cloth. Use a damp
cloth containing a neutral cleaner to wipe off oil or dirt build up.
2. Storage Bin and Scoop
• Wash your hands before removing ice. Use the plastic scoop provided (bin accessory).
• The storage bin/dispenser unit is for ice use only. Do not store anything else in the
bin/dispenser.
• Clean the scoop and the storage bin/dispenser unit liner using a neutral cleaner. Rinse
thoroughly after cleaning.
IMPORTANT
59