Other Functions - Haier washing machine Instruction Manual

Power line hanger
Power line
Cover of packaging
bolt hole
Accessories
Water inlet pipe assembly Drain pipe Drain pipe clamp
Wrench Manual
6
Water inlet valve joint
Drain pipe joint
Packaging bolt
Packaging rod
Drain pipe bracket Strapping tape
11. Application of Detergent Dispenser
Box
Please use foamless or low-foaming washing power suitable for
full-automatic roller-type washing machine.
Washing power dosage refers to the using instruction of washing power.
Excessive washing power will result in heavy foaming and easy
overflowing, thus impacting dissolution of washing power and bringing
difficulty in poaching.
The highest level of softener shall not exceed the MAX mark on the
siphon cap.
In order to achieve the optimal washing effect, it is recommended that
softener is placed into the dispenser box after being diluted by water at
the proportion of 1:1. Excessive softener will damage artificial fiber.
Softener dosage refers to the using instruction of softener.
After procedure running is finished, it is normal that some water is left in
the dispenser box, because the water is supplementing water or
condensate water in the procedure running process.
The handle of the dispenser box is concave and is easy to accumulate
dust, thus please use a piece of cloth to wipe and clean it.

Other Functions

12.
Drying
(Applicable to Drying models)
The washing machine is provided with the function of drying ramie cotton clothes, chemical fiber clothes and
the like, can automatically judge the dry and wet degree of clothes and timely end the drying procedure. The
function is available under the mode of accurate washing and has the following 4 modes to be selected:
Strong drying: suitable for dying ramie cotton clothes and the like.
Weak drying: suitable for drying chemical fiber and other easily damaged clothes.
Ironing dried clothes can be directly ironed by an iron after being taken out.
Timing: users can set the drying time on their owns as needed, with the selective time range of 30 minutes, 60
minutes, 90 minutes and 120 minutes. The four modes can be selected by pressing the "Drying" key.
In drying, please notice:
Whether clothes can be dried, which depends on its material. Before drying, please ensure that clothes are
suitable for washing machine drying.
Before drying, please ensure that the faucet has been opened and it must have cold water.
Dehydrated clothes shall be firstly taken out from the roller and unfolded in a shaking manner, and then are
put into the roller for independent drying.
If excessive clothes to be dried are put at one time, not only the drying effect is not good, but also the clothes
are easy to crease, and the real drying time may be longer than the setting time.
The time of drying fewer clothes or thin clothes may be less than the setting time.
When the weak drying procedure is selected, it is normal that the running time is longer.
In order to reduce the temperature in the roller and prevent scald, cooling and temperature reduction shall be
conducted in the roller before the washing machine finishes drying operation. It is normal that tine displayed
on the display screen remains unchanged for a certain time.
Cancel or Re-select Procedure during the Operation
If the children lock function is started, the following operation can be carried out after the children lock is
unlocked.
If the operation modes (washing mode, washing/drying mode and drying mode) or washing procedures
(ramie cotton, chemical fiber, etc) are required to be reset, press the "Power" key for 2 seconds to shut down
the machine, and then re-press the "Power" key to start the machine, in this way, the needed operation modes
and washing procedures can be reset.
Under accurate washing mode, if only the washing parameters are needed to be reset, slightly press the
"Start/Pause" key to reset the washing parameters (including washing time, poaching times, dehydration time,
dehydration rotation speed, but resettable parameters are required to be selected according to the real
running process of the procedure) as needed, , and then re-press the "Start/Pause" key to start the procedure.
Put liquid softener
Siphon cap
Put washing power
15