Table of Contents
Advertisement
Other functions
1. Control panel lock function:
To prevent children from accidentally changing the settings, the control panel can be
locked by pressing the "Temperature" and "Delay" buttons at the same time. After the
panel is locked, the sign "LOCK" and the remaining wash time will be displayed on the
LED alternately. Now all the function keys except the power switch are locked. Press the
key combination again to cancel this function.
2. power-off memory function:
This machine has a power-off memory function. In the event of unintentional power
failure or if the power has to be cut during a programme cycle, the present cycle will be
saved and operation will resume when the power is switched on again.
3. Error display messages:
1:16
Remaining time 1 hour and 16 minutes.
0:01
Remaining time 1 minute.
60°C
Wash temperature is 60°C.
--°C
No heat (cold wash).
0
No Spin.
800
Spin speed 800r/min.
L--1
Manually selected code when laundry weight is less than 1kg.
L--A
Manually selected code when drum is nearly full.
End
Programme is finished.
Err1:
Cause: Door is not shut properly.
Solution: Shut the door properly.
Err2:
Cause: Drainage error, water not emptied within 4 minutes.
Solution: Clean the filter and check the drain hose for blockage. Take care on
removing filter in case any water remains in the unit. If the error persists, please
contact an approved service engineer.
Err3:
Cause: Temperature sensor error.
Solution: Contact an approved service engineer.
Err4:
Cause: Heating element error or laundry overload that leads to a failure to
reach the set temperature within the specified time (This message is displayed
at the end of a programme).
Solution: Reduce load and then start washing again or contact an approved
service engineer.
Err5:
Cause: Water level not met in 8 minutes.
Solution: Make sure that tap is turned on and water pressure is normal. If
problem still persists, please contact an approved service engineer.
Err6:
Cause: dehumidification/ heating error.
Solution: Please contact an approved service engineer.
Err7:
Cause: Motor overheat error.
Solution: Please contact an approved service engineer.
Err8:
Cause: Water overflow
Solution: Please contact an approved service engineer.
Err9:
Cause: Dryer temperature sensor error.
Solution: Please contact an approved service engineer.
Er10:
Cause: Water level sensor error.
Solution: Please contact an approved service engineer.
Er12:
Cause: Dryer water level sensor error.
Solution: Check whether clothes are dry or not and whether there is water still in
the drum. If so allow excess humidity to escape from the appliance and try the
drying cycle again. If the error persists please contact an approved service engineer.
Er13:
Cause: Dryer heater error.
Solution: Please contact an approved service engineer.
Un6:
Cause: Laundry is unevenly distributed.
Solution: Redistribute laundry to balance the drum. If the problem persists,
please contact an approved service engineer.
EUAr:
Cause: Communication error.
Solution: Please contact an approved service engineer.
13
Hide quick links:
Advertisement
Table of Contents
