Table of Contents
Advertisement
7 Display Screen
It illuminatcs when the "Delay" function is selected.
It illuminates
After selecting the "Delay" function and start the program, the program will analyze
when the
according to the parameter settings and detected clothes weight and may start
washer-dryer
running ahead of time. It is normal (for example, if the delay time is set as "
starts without
press the "Start/Pause" button to start the program, the program will analyze
selecting the
according to parameters settings and detected clothes weight and may immediately
"delay"
start running from "
").
function.
Program progress indication area (including four
parts: "Wash", "Rinse", "Spin" and "Dry". When a
program running ends, corresponding word such
as "Wash" in this zone will go out. Full triangles
indecate the program is running.)
Numerical display area (The program with
automatic weighing function) :"
" diaplays
when the program is not running and in the
process of weighing;remaining time or deplay
time (e.g. "
") diaplays when the program is
running. The program without automatic
weighing fuction: only remaining time or delay
time diaplays. In abnormal conditions, various
alarm codes (e.g. "
" ) diaplay.
Washing time (The
Times of
Spinning time
time does not
rinsing
(After the "Spin"
include water-feed
(After the
program ends,
time and heating
"Rinse"
this area will go
time. After the
program
out.)
"Wash" program
ends, this
Spinning time
ends, this area will
area will go
means the time
go out.)
out.)
for spinning at
high speed.
11
",
Ironing
"Dry" program (It is
Normal
available in the
Low Temp
"Wash & Dry" and
Ironing
"Dry" modes.)
150min
Press the "Dry"
120min
button, the program
90min
will switch among
60min
the options listed on
30min
the right:
Note: The time displayed on the display screen is only for reference and may be slightly different from the
actual time.
Mark of locking door
(After door locks up, the diagram marks
bright.
Under the safe status and the procedure
being circulated, the mark of locking
door will be put out after pressing
"Start/Pause" , then the door can be
openning pressing the "Open" button.)
Synthetics
Heavy
Spinning speed
Heating temperature
(The setting value of
(Maximum allowable
spinning speed
heating temperature
displays. Maximum
varies with programs.
allowable spinning
When no temperature
value displays, it
speed varies with
program.)
indicates that the
washer-dryer will not
heat.)
Prompt information
(Including: alarm messages
related to Drain Filter, Dry
High
Temp
Filter,Imbalance, High Temp
Caution
Caution and Overload.)
Washing program (The washer-dryer described in
this manual is set with 12 washing programs. Three
modes i.e. "Wash", "Wash&Dry" and "Dry" are
corresponding to defferent washing programs.
In the "Wash" mode, Cotton, Memory, Synthetics,
Wool, Silk, Heavy, Quick, Night Wash, High Temp
and Tub Clean program are effective.
In the "Wash & Dry" mode, Cotton, Memory,
Synthetics, Heavy, Quick, Night Wash, High Temp
and Tub Clean program are effective.
In the "Dry" mode, Cotton, Memory, Synthetics, Night
Wash, Heavy, Air Wash and Supporter Dry programs
are effective.)
After starting the washer-dryer, to prevent
washing process from external interference,
activater the child lock function by
simultaneously pressing and holding the
"Temp."and "Speed" button for more than 3s; to
deactivate the child lock function, simultaneously
press and hold the same two button for more
than 3s again.
After the child lock is activated, all the function
buttons (escept the "Off" button) are out of
function.
After the program running ends and the
washer-dryer antomatically shuts down, the child
lock function will automatically cancel. If power
failure occure in the process of program running,
the child lock function will not automatically
cancel and must be manually cancelled after
turning on the washer-dryer again.
12
Advertisement
Table of Contents
