Table of Contents
Advertisement
To connect the drain pipe
Ring the drain pipe on the joint;
Fix the pipe clamp to the groove of drain pipe;
Insert the drain pipe into a floor drainer;
Extend the drain pipe.
State of
Height
Length
extension hose
Rise midway
Within 10cm
Within 1m
Not rise
-
Within 3m
midway
If the drain pipe is too long, remove the pipe sleeve, cut
off the groove part of drain pipe, and then insert the pipe
sleeve into the front end of drain pipe.
If there is a need to extend the drain pipe or change the direction of drain pipe, please contact our
After-sales Service Department.
To install the Anti Rat Cover
Before removing the
packaging
bolts, please fix the Anti Rat Cover to the bottom of the washer dryer.
Lay down the machine, adjust the Anti Rat Cover with the seven holes corresponding the screw holes.Then
tighten the screws and fix it thus securely to the bottom of the machine.
To remove the packaging
bolts
Packaging bolts are used to fix internal components of
washer-dryer during transport and should be removed before
using the washer-dryer.
Screw off all the packaging bolts with a wrench and pull
them out in the direction as shown in the right figure;
Insert the heave of packaging bolt cover into the
packaging bolt cover hole, and then buckle the packaging
bolt cover into the packaging bolt hole in the direction of
arrow as shown in the right figure.
Please keep the dismantled packaging bolts in a safe place
for future handling of the washer-dryer.
To adjust the front
adjustable foot (2)
Loosen the adjusting nut, and then
adjust the adjustable foot (as shown in
Fig.1) until the air bubble of level gauge
is in the red circle (as shown in Fig. 2).
Low
Tighten the adjusting nut (as shown
in Fig. 3).
Fig. 1
7
Floor
drainer
Drain outlet
Pipe clamp
Pipe sleeve
Stay a space
Joint Groove Drain pipe
Within 1m
Floor
Within 10cm
Groove
Pipe sleeve
the
Packaging
Packaging bolt
bolt hole
cover hole
Heave
Adjusting
Loosen
nut
Tighten
High
Adjustable foot
Fig. 2
Fig. 3
11 Preparations before Washing
Check the articles to be washed for special washing requirements and make sure that they are
machine washable and dryable to avoid deformation and damage.
For those articles tainted with much mud and dust, please remove them before washing.
Wash those articles liable to color fading separately from others.
Check pockets and remove coins, sand, hairpin and other things from them.
Tie the ties, buckle the buttons, zip the zippers and sew the openings.
To avoid the sound from buttons, please turn those articles with buttons inside out before putting
them in the washer-dryer.
Do not overload the washer-dryer. Furthermore, please unfold and fluff out the articles before
putting them in the washer-dryer.
When washing small articles and those articles liable to inter-twist and wear, please put
them in net bags for washing, rinsing and spinning to avoid damage.
12 Reference Weight for Different
Types of Clothing
A suit of work clothes
A suit of pajamas
Blended fabric,
Cotton, about 300g
about 800g
Bath towel
Briefs
Cotton, about 300g
Cotton, about 70g
Shirt
Undershirt
Blended fabric,
Cotton, about 130g
about 200g
Socks
Jeans
Cotton, about 30g
Cotton, about 600g
16
Advertisement
Table of Contents
