Display Codes - Haier HW70-1401 User Manual

18

DISPLAY CODES

DISPLAY CODES AND SPECIAL FUNCTIONS
CODES CAUSES
Err1 ¬ Door is not properly shut.
Err2 ¬ Drainage error, water not emptied within 6
minutes.
Err3 ¬ Temperature sensor not properly connected or
damaged.
Err4 ¬ Heater error (Appears at the end of a cycle).
Err5 ¬ The drain hose is in water.
Err6 ¬ Motor error.
Err7 ¬ Motor error.
Err8 ¬ Water exceeds protective level.
End ¬ End of wash cycle.
1:25 ¬The remaining time is 1 hour 25 minutes.
19:25 ¬Status information:Preset time for delayed operation.
Unb After the last rinsing cycle fi nishes,spinning fails completely due to unbalance of the laundry.
¬
¬ Control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after starting a program.
It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Start/Pause" buttons again for 3
seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program : Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn
the program selector again to choose another program.
Alarm sound can be cancelled if it is needed.Please follow the instruction as below:
Switch on the washing machine and turn the program knob to spin cycle, then press the "Delay" and "Extra rinse" button, hold on for
3 seconds.The "bEEP OFF" will be displayed on the screen which indicates that alarm sound has been canceled. To operate the above
steps again so the alarm sound can be recovered and the display will show "bEEP ON".
MAINTENANCE
SOLUTIONS
_ Shut the door properly.
_ Clean the fi lter and check the drain hose for blockage. If error
still exists, please contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Reduce load and then start washing again. If problem still
exists, please contact the maintenance personnel.
_ Make sure the drain hose is not in water.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.