Table of Contents
Advertisement
3
Framing and Clearances
WARNING
Fire Risk
Provide adequate clearances.
•
Around air openings
•
To combustibles
•
For service access.
Locate heater away from traffi c areas.
A. Selecting Heater Location
Several options are available to you when choosing a loca-
tion for your heater. This heater may be used as a room
divider, installed along a wall, across a corner or used in an
exterior chase. See Figure 3.1. This heater may be installed
directly on the fl oor, carpet or raised on a hearth.
DANGER
Electrocution Risk
•
NEVER locate this
into a bathtub or other water container.
•
Contact local building administrator for
information on bathroom intallations.
WARNING
Fire Risk!
•
Prevent contact with sagging, loose
insulation.
•
Do NOT install against vapor barriers or
exposed insulation.
WARNING
Do NOT use this
heater
Immediately call a qualifi ed service technician to inspect
the
heater
and to replace any part of the control system
which has been under water.
WARNING
Fire Risk
•
Comply with all minimum clearances to
combustibles as specifi ed.
Failure to comply may cause fi re.
Quadra-Fire • Village Collection Electric Fireplace • 4030-782 Rev D • 11/05
heater
where it may fall
if any part has been under water.
Note: Minimum and maximum clearances must be
maintained at all times. Illustrations throughout these
instructions refl ect typical installations and are for design
purposes only. Actual installation may vary slightly due to
individual design preferences.
The illustrations and diagrams used throughout these
installation instructions are not drawn to scale.
B. Clearances
Figure 3.1 shows all clearances that must be maintained
around the heater.
WARNING
Fire Risk
Due to high temperature, this
be located out of high traffi c areas.
•
Keep combustible materials such as
furniture, pillows, bedding, papers,
clothes and curtains at least 12 in.
(305 mm) from the front of the heater.
31-7/8 in.
(810 mm)
36-1/4 in.
(921 mm)
22-1/2 in.
(572 mm)
45 in.
(1143 mm)
36-1/4 in.
(921 mm)
Figure 3.1
Heater Locations
heater
should
14 in.
(356 mm)
36-1/4 in.
(921mm)
14 in.
1 in. (26 mm) min.
(356 mm)
7
Advertisement
Table of Contents
