How To Use The Remote Control; Operations; General Operation - Pyle PSBV400 Owner's Manual

HOW TO USE THE REMOTE CONTROL
1. BATTERY INSTALLATION
a. Remove battery cover.
b. Install two "MA' size batteries (included) into the battery compartment
according to the polarity markings inside battery compartment.
c. Close battery cover.
+
,--------------------------,
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure
to
follow the correct polarity when installing the
batteries as indicated next to the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together(e.g. Alkaline.
Rechargeable and Carbon-zinc) or old batteries with fresh
ones.
4. If the device is not to be used for a long period of time, remove
the batteries to prevent damage or injury from possible battery
leakage.
5. Do not try to recharge batteries which are not designed
to
be
recharged. They can overheat and rupture.
6. Do not dispose of batteries in fire. Batteries may explode or
leak.
2. EFFECTIVE SCOPE OF THE REMOTE CONTROL
The remote control has an operating range which is less than 16 feet and
at 30 degree angle left or right away from the system.
NOTES:
When there is an obstacle between the
unit and the transmitter, the transmitter
may not operate.
When direct sunlight, an incandescent
lamp, fluorescent lamp or any other
stnong light shines on the nemote sensor
of the unit, the remote operation may be
unstable.
OPERATIONS
1. GENERAL OPERATION
1) Press the POWER button on the front panel of the unit to turn the unit
to Standby mode.
2) Press the STANDBY Button on the unit or POWER button on remote
control to power on the unit.
3) Press the INPUT Button on the unit or remote control repeatedly to
select the input sources to HD, PC, Radio, CD, AUX1 or AUX2 as
desire.
4) Press the VOL +NOL· Buttons on the unit or remote control to adjust
volume as desire.
5) Press the T+rr-/B+/B- buttons on the remote control to adjust treble
and bass.
6) Press the SRS Button on the remote control to turn the Surround
Sound Effect ON, press again to turn it OFF.
7) During listening, press the MUTE Button on the unit or remote control
to turn off the sound temporary (MUTE will appear on the display),
press again to tum the sound back.
8) During listening, press the RST Button on the remote control to reset
the sound level to default settings.
9) When finished listening, press the STANDBY button on the unit or
POWER button on remote control to tum off the unit(Standby mode).
NOTE: If you will not use the unit for long period of time, please
power off the unit by press POWER button on the unit to cut off AC
supply.