Generac Power Systems TMS200 Specification page 2

Cabinet Specifications
2 of 2 Dimensions
Weight
Construction
Mounting Options
Installed
Electrical Specifications
Voltage/Phase/Amps
Breaker
Fault Current Rating
200A Camlock Generator Connection
Input to Generator
Output to Site
Generator Annunciator Connector
Alarm Terminal Board
Additional Components
Mounting Bracket
Alarm Cable
Enclosure Gasket
Specification characteristics may change without notice. Dimensions and weights are for preliminary purposes only. Please consult a Generac Power Systems Industrial Dealer for detailed installation drawings.
UL Listed - Non-Automatic Transfer Switch & Suitable for Service Equipment
Installation Mounting Bracket
100' length of multi-conductor cable
Full Exterior x 2"W x 1/2"D Closed Cell Gasket
Generac Power Systems, Inc. • S45 W29290 HWY. 59, Waukesha, WI 53189 • generac.com
©2013 Generac Power Systems, Inc. All rights reserved. All specifications are subject to change without notice. Bulletin 0195630SBY-E / Printed in U.S.A. 03/13/13
Application and Engineering Data
20"W x 10"D x 36"H
53.8 lbs.
Single Chamber with Main Door
0.080 14GA Aluminum
UL Type / NEMA 3R Rated
Powder Coat Finish for Corrosion Resistance
Stainless Steel Hardware
3-Point Latching System with Pad-Lockable Handle
Wall
H-frame
Pre-wired alarm terminal strip
120/240 Single-Phase, 200A
120/208 3-Phase, 200A
120/240 3-Phase, 200A
Generac 200 amp Utility Breaker
Generac 200 amp Generator Breaker
22k AIC Rated
Single-Phase: Black L1, Red L2, White-Neutral, Green-Ground
3-Phase: Black L1, Red L2, Blue L3, White-Neutral, Green-Ground
Uses 4 CH E1016 Male Connectors
Mating Connector – CH E1016 Female
350MCM - #6 AWG
350MCM - #6 AWG
Deutsch DTM04-12PA-L012
Generator Run Alarm
Generator Fail – Shutdown Alarm
Generator Fail – Non Shutdown Alarm
Low Fuel Alarm
Generator Theft Alarm
AC Utility Fail Alarm
Shipped loose with switch