Activation Chart - Generac Power Systems Stationary Emergency Generator Installation Manual

1.12.1 ACTIVATION CHART

CHOOSE LANGUAGE
Display Reads:
Language
- English
Escape
Display Reads:
Activate me (ENT) or
ESC to run in manual
Escape
Display Reads:
To Activate go to
www.activategen.com
Escape
ENTER ACTIVATION CODE (Passcode)
Display Reads:
Serial 123456789
Passcode XXXXX +/-
Escape
Display Reads:
"SELECT HOUR (0-23)"
"- 6
Escape
Use ARROW keys to scroll to desired language.
Press ENTER to select.
+
Enter
Press ENTER to begin the activation process.
Enter
If you do not have your activation code, go to
www.activategen.com or call 1-888-9ACTIVATE
(922-8482).
If you already have your activation code, wait 3-5
seconds for the next display.
Enter
Use ARROW keys to scroll and find the first num-
ber of your Activation Code.
Press ENTER to select.
Repeat this step until all digits have been entered.
Use ESCAPE to correct previous digits.
Enter
Activation is complete when all digits are entered
above and your screen shows this display.
Follow the controller prompts to continue setting
the time function. Refer to your Owner's Manual
+"
with questions.
Enter
General Information
TROUBLESHOOTING
If the wrong language is chosen, it can be
changed later using the "edit" menu.
If ESCAPE is pressed instead of ENTER, your
generator will only run in manual mode (for
test purposes) and NOT ACTIVATED will be dis-
played. You will need to remove the generator
control panel fuse AND disconnect the T1, N1,
N2 connector in the external connection box (if
equipped) or disconnect the utility input (main
breaker) to the transfer switch for 3-5 seconds.
Reconnect and start over with step 1.
TROUBLESHOOTING
What happens if "Wrong Passcode Try Again"
appears?
Reenter the activation code. If a second attempt
is unsuccessful, check the number against the
code given on activategen.com. If it is correct
and the generator will not accept it, contact
1-888-9ACTIVATE (922-8482).
15