Black Mark Requirements - Printek MtP Series Programmer's Manual

Printek Emulation

Black Mark Requirements

The position described below is designed to be used when seeking a Black Mark at the beginning of a print job.
This position and will require little or no reverse paper motion resulting in the fastest throughput and best
printing alignment, and reduces the potential for paper jams. However, the vertical position of the Black Mark
is entirely dependant on the application program that is controlling the printer.
The Black Mark must be printed on the front side of the paper for non "LP" models, and may optionally be
printed on the back side of the paper for the "LP" models. Refer to the printer's Operator's Manual for
instructions on selecting which sensor is used.
20