Connecting Optional Spool Gun - Hobart Welding Products Handler 210 MVP Owner's Manual

5-15. Connecting Optional Spool Gun

Spool Gun
Ç Ç Ç Ç
6
MIG Gun
.
Be sure that gun end is tight against drive assembly.
Incorrect
Gun Not Seated
10
7
3
1
3
Exposed O-rings
will cause shielding
gas leakage.
8
9
5
2
4
Correct
Gun Fully Seated
1 Drive Assembly
2 Spool Gun
3 Gun Securing Thumbscrew
4 Gun End
Loosen thumbscrew. Insert end
through opening until it bottoms
against drive assembly. Tighten
thumbscrew.
Spool gun must be inserted
completely to prevent leakage of
shielding gas.
5 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
6 Spool Gun/MIG Gun Switch
Place switch in Spool Gun position.
7 Polarity Changeover Terminal
Block
To make proper polarity connection,
see Section 5-5.
Close door.
8 Wire Feed Speed Control
Wire feed speed control controls
rate at which the is fed through the
3
welding gun to the weld puddle.
9 Voltage Control
Arc voltage is controlled by welding
power source Voltage control (see
Section 6-2 or door chart for
appropriate setting).
10 Trigger
Press trigger to energize welding
power source contactor, start
shielding gas flow, and begin wire
feed.
804 695-A / 804 696-A
OM-249 498 Page 25