Section 3 - Installation; Specifications; Duty Cycle And Overheating; Installing Gun With Four Pin Connector - Hobart Welding Products HR200 Owner's Manual

3-1.

Specifications

Wire Diameter Range
Flux Cored Wire: .023–.045 in.
(0.6–1.1 mm)
Solid Wire: .023–.045 in. (0.6–
1.1 mm)
3-2.

Duty Cycle And Overheating

60% Duty Cycle At 200A Using Mixed Gases
Overheating
3-3.

Installing Gun With Four Pin Connector

allen_wrench allen_set
1
pliers needlenose
solderiron
stripcrimp
allen_wrench allen_set
torque screwdriver
SECTION 3 – INSTALLATION
Cooling Method
Air Cooled Welding Gun For
GMAW And FCAW Welding
0
15
Minutes
tools/
flathead
3
knife steelbrush
2
tools/
Ref. 284972-A
heavy-duty workclamp
flathead
Duty Cycle Rating
60%: 200 A With Flux Cored Wire
60%: 200 A With CO Shielding
2
Gas
60%: 200 A With Mixed Gases
Duty Cycle is percentage of 10 minutes that unit can weld at rated
load without overheating.
NOTICE – Exceeding duty cycle can damage unit and void warranty.
A or V
OR
Reduce Duty Cycle
philips head
1 Gun Securing Knob
2 Gun End
Loosen knob. Insert gun end until it bottoms
against drive assembly. Tighten knob.
nutdriver 3 Gun Trigger Plug
Insert into receptacle and tighten threaded
collar.
allen_wrench
See power source manual for wire threading
procedure.
light-duty workclamp wirecutter
pliers
philips head wrench
solderiron
Weight
With 15 ft (4.6 m) Power Cable:
6.9 lb (3.1 kg)
sduty1 5/95
wrench
crescent wrench
Turn off and disconnect input
power.
chippinghammer
allen_set
frontcutter
needlenose
crescent wrench
OM-286182 Page 5
stripcrimp
flat
knife
heavy-duty work