Care And Maintenance; Removing And Cleaning The Lter; Air Conditioner Installation Electrical Requirements; Installation Hardware - Friedrich XQ05 Installation And Operation Manual

Care and maintenance

To remove filter
Simply turn the unit off and pull the filter frame up and towards you (See
Figure 6). Clean with warm water and a mild detergent, rinse, dry, and
replace by sliding the filter back into position behind the front panel.
Installation instructions
NOTE: This section includes installation instructions for window mount and thru-the-wall mount methods. X-Star
thru-the-wall installation. Mounting the unit in a window will require a window mounting accessory kit, available through your Fried rich dealer.
WARNING
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner's
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
READ THIS FIRST! Electrical Requirements
IMPORTANT: Before you begin the actual installation of the air conditioner,
be sure your electrical requirements are as described below. Consult an
electrical professional as necessary to insure home wiring is per local
electrical codes.
Items required for installation
ITEM NO. DESCRIPTION
1 SCREW, SHEET METAL, #8 x
2 SCREW, PHILLIPS, TRUSS HEAD, #8 x ½"
3 SCREW, HEX, #8 x
4 SCREW, PHILLIPS, #8 x 1 ¼"
5 GRAY GASKET, FOAM, 1" x 1 ½" x 42"
6 WHITE GASKET, FOAM, 1" x 1 ½" x 48"
ITEM 1 ITEM 2
ITEM 7 ITEM 8
(provided in straight cooling units only)
QTY.
" 8
4
" 10
2
1
1
ITEM 3 ITEM 4
ITEM 9
Figure 6
heat/cool units are designed for permanent
®
CIRCUIT PROTECTION - An overloaded circuit will invariably cause mal-
function or failure of an air conditioner, therefore, it is necessary that the
electrical protection is adequate. All portable chassis models require a 15
amp fuse or circuit breaker for over-amperage protection. Due to momen-
tary high current demand when your air conditioner is started, use a "TIME
DELAY" fuse or a HACR type circuit breaker. Consult your dealer or power
company if in doubt.
Your air conditioner must be connected to a power supply with the same A.C.
voltage and hertz as marked on the unit nameplate. Only alternating current
(A.C.), no direct current (D.C.), can be used.
The power cord has a plug with a grounding prong of approved type and a
matching plug receptacle with ground is required. Refer to page 3 for the
correct type of plug receptacle for your model.
WARNING: NEVER CUT OR REMOVE THE GROUNDING PRONG
FROM PLUG. NEVER USE EXTENSION CORDS TO OPERATE AN AIR
CONDITIONER.
ITEM NO. DESCRIPTION
7 LEFT SIDE CURTAIN ASSEMBLY
8 RIGHT SIDE CURTAIN ASSEMBLY
9 DECORATIVE FRONT PANEL
10 CABINET OR SLEEVE
11 AIR CONDITIONING UNIT
ITEM 5
ITEM 10
QTY.
1
1
1
1
1
ITEM 6
ITEM 11
5