Subscribe to Our Youtube Channel
Related Manuals for Primera RW-12
Summary of Contents for Primera RW-12
- Page 1 Unpack and Inspect Setup Attach Label Stock Operation Specifications 511279-120110 © 2010 All rights reserved...
- Page 2 No part of this document may be photocopied, reproduced, or translated into another language without prior written consent. Trademark Acknowledgments: Primera is trademark of Primera Technology Inc. Windows is a registered trademark of Microsoft Corporation. All other trademarks are the property of their respective owners.
- Page 3 Section 1: Unpack and Inspect Thank you for purchasing the RW-12. The RW-12 Label Rewinder makes it easy to rewind large quantities of labels. Its perfect for use with Primera’s entire line of LX- Series Label Printers and many other label printers.
- Page 4 Section 2: Setup The RW-12 Rewinder is fully assembled inside the box. However, to get started you will need to plug in the power cable, switch the unit on and install the stability stand. Please follow the instructions below to install the stability stand.
- Page 5 Section 3: Attach Label Stock 1. Locate a suitable core on which to rewind labels. The core should be equal to or less than the width of the liner width. 2. Remove the Chuck Support Bar by unscrewing the thumb screw at the base. 3.
- Page 6 8. Before you attach the label stock print a header of approximately 2 feet (61 cm) of label stock. 9. Feed the header under the dancer arm. 10. Attach the stock to the core using tape. 11. Turn on the rewinder. 12.
- Page 7 Section 5: Specifications Maximum Roll Diameter: 10” (254 mm) Core Size: 3” Maximum Roll Width: 8.5” (216 mm) Minimum Roll Width: 1” (25.4 mm) Electrical Rating: 29V, 2.5 A Power Input: 100-240 VAC, 50/60 Hz Weight: 17 lbs (7.7 kg) Dimensions: 17.5”W x 6.5”D x 13.5”H (444.5mm x 165.1mm x 342.9mm)
Need help?
Do you have a question about the RW-12 and is the answer not in the manual?
Questions and answers