Maintenance; Optional Accessories - Powermatic 64A Operating Instructions And Parts Manual

Maintenance

Before doing maintenance on
the machine, disconnect it from the electrical
supply by pulling out the plug or switching
off the main switch! Failure to comply may
cause serious injury.
Good saw operation requires periodic preventive
maintenance.
1. Keep the inside of the cabinet and trunnion
areas clean. A stiff brush will remove
sawdust before it cakes, and pitch or gum is
easily removed with a commercial solvent.
2. After cleaning the tilting and raising worm,
and worm gear

Optional Accessories

708295 Tenoning Jig
709380 Zero Clearance Insert
708818 Push Stick
709721 Featherboard
2042367 Mobile base for Model 64A with 50" Rip Capacity, Ext. Table and Legs
2042370 Mobile base for Model 64A with 30" Rip Capacity, Ext. Table and Legs
2195076K Accu-Fence system, 30"
2195077K Accu-Fence system, 50"
6290550 Miter Gauge
6290694 Table insert.
6290695 Dado insert.
6441000Z Legs, set of two.
6682004 Rout-R-Lift.
6827029 Model 64A 27" x 35-5/8" Extension Table
6827033 Model 64A 27" x 35-5/8" Extension Table for Rout-R-Lift
6827034 Model 64A 27" x 17" Extension Table for Rout-R-Lift
6827036 Model 64A 27" x 17" Extension Table
segments, and the
trunnions, grease these three areas with a
good grade non-hardening grease.
3. The table surface must be kept clean and
free of rust for best results. An occasional
coat of paste wax on the table will allow the
wood stock to glide smoothly across the
work surface.
An alternative is white talcum powder
applied with a blackboard eraser rubbed in
vigorously once a week to fill casting pores
and form a moisture barrier. This method
provides a table top that is slick and allows
rust rings to be easily wiped from the
surface. It is also important to note that
talcum powder will not stain wood or mar
finishes as wax pickup can.
26