Overload Protection (Kohler-Powered Units); Servicing Optional Spark Arrestor (Kohler-Powered Units) - Hobart Welding Products CHAMPION ELITE Owner's Manual

9-6. Overload Protection (Kohler-Powered Units)

2
.
Fuses F1, F2 located on
bracket behind left side
panel.

9-7. Servicing Optional Spark Arrestor (Kohler-Powered Units)

1
1
.
Fuse F6 located in
harness behind left
side door.
.
A complete Parts List is available at www.HobartWelders.com
3
!
Stop engine. Disconnect
negative (−) battery cable.
1 Fuse F1 (See Section 11-1)
F1 protects the weld excitation
winding from overload. If F1 opens,
weld output stops or is low.
2 Fuse F2 (See Section 11-1)
F2 protects the generator power
excitation winding from overload. If
F2 opens, generator power output
stops or is low.
3 Fuse F6 (See Section 11-1)
F6 protects the engine wiring sys-
tem from overload. If F6 opens,
engine will not crank.
Replace any open fuses. Reinstall
cover before operating.
.
If a fuse opens, it usually indi-
cates a more serious problem
exists. Contact a Factory Au-
thorized Service Agent.
Tools Needed:
3/8 in.
244 029-A
!
Stop engine and let cool.
1 Spark Arrestor Screen
Clean and inspect screen. Replace
spark arrestor if screen wires are
broken or missing.
Tools Needed:
1/4 in.
244 029-A / Ref. 801 682-A
OM-240 438 Page 43