Toshiba MW27H63 Owner's Manual page 49

a video tape
If you connect the unit to another VCR or Camcorder, you can duplicate
a previously recorded tape. Make all connections before turning on the
power.
INPUT
STOP
REC
#
_ ._ S P E E D
®
Preparation:
* Press TV/VCR to select the TVNCR mode.
* Load a cassette tape with the erase prevention tab
intact.
Load a previously recorded tape into the playback VCR
or Camcorder.
Press SPEED to select the desired tape speed
SP or SLR
SPEED
R_TUB_
[::::3
It is recommended to set the Speed to
the SP mode on the recording VCR for
best results.
Press iNPUT repeatedly to select AUDIO/VIDEO input position.
"VIDEO1" or "VIDEO2" will appear on
the screen.
INPUT
ZOOM
©
VIDEO1 : on the rear panel
VIDEO2: on the front panel
Press REC.
6
Press PLAY on the playback VCR or camcorder.
Press STOP when you finish after duplicating.
STOp
(]E)
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs and other materials,
is prohibited under the Copyright Laws of the United States
and other countries, and may subject you to civil and/or
criminal liability.
Connection with second video recorder
• Select "VIDEO1" in step 2.
PlaybackVCR
To VIDEO OUT_ _L_)L_To AUDIO (R) OUT
AudioNideo cable (not supplied)"T" _- To AUDIO (L) OUT
Recording VCR
Illustration of
MW20H63
To AUDIO (R) IN
To AUDIO (L) IN
Connection with Camcorder
,' Select "VIDEO2" in step 2.
Playback Camcorder
Recording VCR
To AV Jack
Illustration of
MW20H63
To AUDIO (R) IN
AUDIO (L) _N
To VIDEO IN AudioNideo cane (not supplied)
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer's
instructions. A typical camcorder dubbing hookup is
shown above.
o
E"
o
(t}
I 5Y40101A indb 49
÷
49/
12'21_006 11:I8130AM I