Framing - Heatilator SILH50ENH Owner's Manual

C. Framing
Figure 3.2 shows a typical framing (using 2 x 4 lumber) of
the heater, assuming combustible materials are used. All re-
quired clearances to combustibles around the heater must
be adhered to.
14 in.
(356 mm)
Figure 3.2 Framing the Heater
8 Heatilator • SILHOUETTE Series Electric Fireplace • 4030-155 Rev K • 04/05
A*
*If using the PBT or BKT Cabinet Trim Kits,
increase the width (A) by 1-1/4 in. ( 32 mm)
and header height (B) by
30 in. min.
(762 mm)
3/4 in. - 12 in.
(19 mm - 305 mm)
B*
(header height)
5/8 in. (16 mm) .
(CEILING)
C
Mantel height listed is measured
from the BASE of the heater.
Model A
in. 36-1/4 31-1/4
SILH50E
Series mm 921 794
in. 41-1/4 34-7/8
SILH60E
Series mm 1048 886
B C
31-1/2
800
35
889