Heatilator SILH20E-B Owner's Manual
Heatilator SILH20E-B Owner's Manual

Heatilator SILH20E-B Owner's Manual

Electric fireplace/insert

Advertisement

Quick Links

Models:
SILH20E-B
Electric Fireplace/Insert
Important operating
a n d m a i n t e n a n c e
instructions included.
WARNING
If the information in these instruc-
tions is not followed exactly, a
fi re may result causing property
damage, personal injury, or death.
• Do not store or use gasoline or other fl am-
mable vapors and liquids in the vicinity of
this or any other appliance.
• Comply with all minimum clearances to
combustibles as specifi ed. Failure to
comply may cause house fi re.
Made in China
CAUTION
DO NOT DISCARD THIS MANUAL
Read, understand
and follow these
instructions for safe
i n s t a l l a t i o n a n d
operation.
Heatilator • SILH20E-B • 4038-895 Rev C • 11/05
Owner's Manual
Installation and Operation
Leave this manual with
party responsible for
use and operation.
WARNING
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
Glass and other surfaces are hot
during operation and cool down.
Keep children away.
CAREFULLY SUPERVISE children in same room
as heater.
Alert children and adults to hazards of high
temperatures.
Keep clothing, furniture, draperies and other
combustibles away.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SILH20E-B and is the answer not in the manual?

Questions and answers

Summary of Contents for Heatilator SILH20E-B

  • Page 1 Alert children and adults to hazards of high combustibles as specifi ed. Failure to temperatures. comply may cause house fi re. • Keep clothing, furniture, draperies and other combustibles away. Made in China Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 2 The insert you have selected is designed to provide the utmost in safety, reliability and effi ciency. Your new Heatilator electric fi replace/insert will give you years As the owner of a new fi replace/insert, you’ll want to read and of durable use and trouble-free enjoyment.
  • Page 3: Table Of Contents

    B. Thermostat ....... . 14 Note: An arrow ( ) found in the text signifi es change in content. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 4: Listing And Code Approvals

    This heater is tested and approved as a decorative heater. It should not be factored as a primary heat source in Heatilator is a registered trademark of Hearth & Home Tech- residential heating calculations. nologies Inc. •...
  • Page 5: Getting Started

    Actual installation may vary slightly due to individual design preferences. The illustrations and diagrams used throughout these installation instructions are not drawn to scale. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 6: A. Selecting Heater Location

    Immediately call a qualifi ed service technician to inspect heater and to replace any part of the control system which has been under water. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 7 9-3/4 in. (248 mm) 1/2 in. min. (13 mm) 9-3/4 in. 1 in. min. (248 mm) (26 mm) Model inches 23-1/2 SILH20E-B Figure 3.1 Heater Locations Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 8: Frame The Heater

    (711 mm) high for the 23 in. heater. See Section 6.C. for mantel specifications. 18-1/4 in. (464 mm) (header height) 23-1/2 in. (597 mm) 9-3/4 in. (248 mm) Figure 3.2 Framing the Heater Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 9: Installation

    fl anges on both sides of the heater and nail to the framing. • To fi nish out the heater, follow the instructions found in Section 6. • To complete heater installation, see Section 5. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 10: As An Insert

    Turn bolts in until the insert is level. Use appropriate wire to meet local and national • A retaining method may be needed to secure the heater codes for rated power consumption. in place. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 11 FLAME MOTOR THERMAL HIGH BLUE LIMIT RED 2 PIN 1300 WATT HEATER 16 Ga YELLOW 4 PIN 16 Ga AMP AC BLOWER MOTOR ORANGE 3 PIN Figure 4.1 110V/120V Wiring Diagram Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 12 Black White Cable Thermistor Sensor Power Cord Wire with Ribs No Connection Black Wire to Heater Power Cord Black Wire Switch Brown Assembly Cable Black Figure 4.2 110V/120V Wiring Diagram Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 13: Accessories

    Do NOT operate this heater without the front face installed. Installation of other optional accessories may be done at this time. The heater is now ready for operation. See Section 7. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 14: Finishing

    Note: Finishing materials are normally installed behind the nailing fl anges or up to the sides of the nailing fl anges. Allow room for the front to be added and the heater to be anchored. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 15: Operating Instructions

    Do NOT store fl ammable materials close to heater. • Keep all such liquids well away from the heater while it is in use. Figure 7.1 General Operating Parts Combustible materials may ignite. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 16: Troubleshooting

    Odor. The heater may emit a slight, harmless odor when fi rst used. This is a normal condition caused by initial heating of the internal parts and will not occur again. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 17: Maintenance And Service

    Place the new bulb in the socket. See Figure 9.2. Follow directions on the light bulb package for handling requirements. • Reinstall the hearth assembly. Bulbs Figure 9.2 - Replacing the Bulbs Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 18: Maintenance Task List

    2. Confi rm there is no damage to glass or glass frame. Replace as necessary. 3. Clean glass using a non-abrasive cleaner such as Brasso©. Circulation Compartment 1. Remove any foreign objects. 2. Verify unobstructed air circulation. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 19: Reference Materials

    1 in. (26 mm) 1 in. (26 mm) 18-5/8 in. (473 mm) 12-5/8 in. (321 mm) 18 in. (458 mm) 23 in. 3-1/4 in. (585 mm) (83 mm) 25-3/4 in. (654 mm) Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 20: Optional Components

    Black Front w/Mesh 26 in 21 in. DFED2621 Deluxe Black Front w/Mesh 26 in. 21 in. DFED4021 Black Front w/Mesh 40 in. 21 in. DFED4028 Black Front w/Mesh 40 in. 28 in. Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 21: Service Parts

    C. Service Parts SILH20E-B Service Parts Beginning Manufacturing Date: Apr 2005 Exploded Parts Diagram Ending Manufacturing Date: Active SILH20E-B 18 - Log Set Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 22: Service Parts

    Thermostat Wire RBW 4038-111 Control Switch Wire 4038-814 Thermostat 4038-849 Installation Manual 4038-895 Glass Retainer - Top 4038-012 Strain Relief Bushing (switch wires) 25756 Gasket Kit 4038-900 Refl ective Flame Decal 4021-190 Heatilator • SILH20E-B • 4038-895 Rev C • 11/05...
  • Page 23: Limited Warranty

    How to Obtain Service. To obtain service under this warranty you must: 1. Send written notice of the claimed condition to Heatilator Technical Service Department, Hearth & Home Technologies Inc., 1915 W. Saunders St., Mt. Pleasant, IA 52641. 2. Provide proof of purchase, model number, serial number, and manufacturing date code to HHT.
  • Page 24: Contact Information

    Hearth & Home Technologies Inc. 1915 W. Saunders Street Mt. Pleasant, Iowa 52641 www.heatilator.com Please contact your Heatilator dealer with any questions or concerns. For the number of your nearest Heatilator dealer, please call 1-800-927-6841. – NOTES – CAUTION DO NOT DISCARD THIS MANUAL •...

This manual is also suitable for:

Silh20e

Table of Contents