Operating Instructions; Manual Controls - Heatilator SILH50ENH Owner's Manual

8

Operating Instructions

WARNING
Fire Risk
• Do not operate heater before reading and
understanding operating instructions.
Failure to operate heater properly may
cause fi re.
A. Manual Controls
Access Controls
• Controls are located behind the lower grille panel. To
access the controls, lift up on the lower grille panel and
rotate it forward.
Function of Manual Controls
• Main Power Switch
- Main power switch is used to provide power to all
controls. When the main power switch is on, the heater
is turned on by the manual control on the heater,
the remote control (optional) and/or the wall switch
(optional).
- When the main power switch is off, the manual
switches, remote control and wall switch will not
work.
MOTION
Figure8.1 Dashboard Controls
Heatilator • SILHOUETTE Series Electric Fireplace • 4030-155 Rev K • 04/05
HEATER/BLOWER ASSEMBLY SWITCH
MOTION INTENSITY THERMOSTAT
INTENSITY
- It is recommended that during long periods of non-
usage that the main power switch is turned to the "OFF"
position.
• Flame/Ember Bed Intensity Control
- Turn the control knob clockwise to increase the
intensity.
- Turn the control knob counter-clockwise to reduce the
intensity.
• Flame/Ember Bed Motion Control
- Turn the control knob clockwise to increase the
motion.
- Turn the control knob counter-clockwise to reduce the
motion.
• Heater/Blower Assembly Switch
- The heater/blower assembly will operate only if the
switch is turned on.
- When the heater/blower assembly switch is in the
"OFF" position, the heater can operate with fl ame but
no heat.
HEATER MAIN
LEARN
POWER
THERMOSTAT
MAIN POWER SWITCH
LEARN
15