Table of Contents
Advertisement
Functional Description
Specifications
Components and Controls
initial hose Reel Setup
Read the entiRe imPORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
1. Choose a mounting location that is free of electrical
wiring or other obstructions, and is sturdy enough
to support the weight of the Reel and hose as well
as the force used to extend and retract it. Purchase
four bolts able to support the same forces.
2. Make a paper template from the mounting
plate of the Reel. Mark the center of the bolt
holes in the desired mounting location.
Page 4
Hose Length
Maximum Air Pressure
Air Inlet
Outlet to tool
Figure a
For technical questions, please call 1-800-444-3353.
30'
250 PSI
1/4" -18 NPT
Hose
Mounting Plate
Inlet from
Compressor
(on Mounting
Plate)
Reel Flange
3. Check for hidden wiring, then, drill holes to
accommodate the bolts (not included).
4. Mount the Reel and secure in place with four bolts.
5. Align the holes of the Handle with the holes on
the Reel Flange and secure the Handle in place
with the three Screws, Nuts and Washers.
Handle
Item 40131
Advertisement
Table of Contents
