Spare Parts List - Philips FPF42C128135UA-52 Service Manual

9.3 List of abbreviations
ADM
Burn-in rack
CPU
DOXE
DOXO
DOYSD
DOYSU
External power ON
External power OFF
Flexible cable
Flicker
Gradation
OPUMP
Oscilloscope
Panel
Panel voltage
Parts
PDP

10. Spare Parts List

For spare parts list see chapter 5
Address driver module
Test equipment of the shelf test in
which the PDP unit is left to stand in
drive condition
The unit for controlling the circuit
operation
The control voltage for even-
numbered lines in the X direction
The control voltage for odd-numbered
lines in the X direction
Used in the drive voltage in the Y
direction (down)
Used in the drive voltage in the Y
direction (up)
Running the external powers (Vcc, Va,
Vs) on the designated voltage. Unless
otherwise specified
Making the external powers (Vcc, Va,
Vs) to stop their operation completely.
Unless otherwise specified
The cable to connect the electric
circuit to the panel
Continuous switching between bright
and dark views by the PDP itself
Shading of the display colour
The name of a circuit where the
current from X/Y-SUS is returned
A device that allows the flow and
strength of the running current to be
visually checked and measured
The indication part of the plasma
display panel (PDP)
The voltage required operating the
PDP normally
Each PC board and parts mounted in
the PC boards
Plasma display panel abbreviated
Spare Parts List FHP PDP
Probe
Protection cover
ROM
SCAVIO
SDM
SUS
Tapping
Unit of COM
Va
Vcc
Vs
Solid white
X-SUS
YCOM
YCOMDV
Y-SUS
10. EN 33
A cable with contact finger that can
transfer the status of the electric circuit
to be measured to an oscilloscope
A cover made of aluminium to protect
the PDP entirely during test
Memory that stores the drive
sequence and other data
Scaler Control Audio Video Output &
Input
Scan driver module
X-SUS or Y-SUS
Light impact
The unit of circuits connected to the
panel with flexible cable (YCOM UP/
DOWN, X-BUS UP/DOWN, address
sections, the unit of PC boards in
ACOM 1 to 5).
The power supply at 60 V, which is
used to write data on the panel
The power supply at 5 V, which is used
to operate the logic section mainly
The power supply ranging from 127 V
to 180 V, which is used to maintain
display data. In addition, this can serve
as the primary side for the secondary
voltage (Vw, -Vy, Vsc)
A condition when the screen display is
entirely white
The name of the circuit that controls
the panel operation in the X direction
The circuit used to output a panel Y
line selection signal and the voltage of
a display data keep signal
The name of the panel drives voltage
signal output from YCOM UP/DOWN
section
The name of the circuit that controls
the panel operation in the Y direction