110-120 V~ Double Insulated Tools: Tools With Two Prong Plugs; Grinder Safety Warnings - Central Machinery 6510 Set Up And Operating Instructions Manual

110-120 V~ double insulated
tools: tools with two prong
plugs
Outlets for 2-prong plug
1. To reduce the risk of electric shock,
double insulated equipment has a po-
larized plug (one blade is wider than
the other). This plug will fit in a polar-
ized outlet only one way. If the plug
does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact
a qualified electrician to install the
proper outlet. Do not change the plug
in any way.
2. Double insulated tools may be used
in either of the 120 volt outlets shown
in the preceding illustration. (See
Outlets for 2-prong plug.)

Grinder Safety Warnings

For Your Own Safety read instruction
manual Before Operating Grinder
1. Wear eye protection.
2. Use grinding wheel suitable for speed
of grinder.
3. Replace cracked wheel immediately.
4. Always use guards and eye shields.
5. Do not overtighten wheel nut.
6. Use only flanges furnished with the
grinder.
Page 6 For technical questions, please call 1-800-444-3353.
7. Adjust distance between wheel and
work rest to maintain 0.125 inch or
less separation as the diameter of the
wheel decreases with use.
8. Frequently clean grinding dust from
beneath grinder.
9. Wear a full face shield over ANSI-
approved safety goggles during use.
10. Do not grind with side of wheel un-
less wheel is specifically designed for
that type of grinding.
11. dO nOt Operate With anY
Guard diSaBled, damaGed,
Or remOVed. moving guards
must move freely and close in-
stantly.
12. The use of accessories or attach-
ments not recommended by the
manufacturer may result in a risk of
injury to persons.
13. When servicing use only identical
replacement parts.
14. Only use safety equipment that has
been approved by an appropriate
standards agency. Unapproved
safety equipment may not provide
adequate protection. Eye protection
must be ANSI-approved and breath-
ing protection must be NIOSH-ap-
proved for the specific hazards in the
work area.
15. Industrial applications must follow
OSHA guidelines.
16. Maintain labels and nameplates on
the tool. These carry important safety
information. If unreadable or miss-
ing, contact Harbor Freight Tools for a
replacement.
SKU 6510