Table of Contents
Advertisement
Quick Links
20 INCH DISC
SANDER / GRINDER
Model 45725
ASSEMBLY and OPERATING
INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright © 2001 by Harbor Freight Tools
. All rights reserved. No portion of
this manual or any artwork contained herein may be reproduced in any shape or
form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Advertisement
Table of Contents
Related Manuals for Central Machinery 45725
Summary of Contents for Central Machinery 45725
- Page 1 . All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353...
-
Page 2: Specifications
Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protective, electrically non-conductive clothes and non-skid footwear are recommended when working. Wear restrictive hair covering to contain long hair. Page 2 SKU 45725... - Page 3 If there is any doubt, do not operate the tool.. 20. Maintenance. For your safety, maintenance should be performed regularly by a qualified technician. Page 3 REV05/02 SKU 45725...
- Page 4 Unpacking When unpacking, check to make sure parts listed on page 8 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible. Warning! Operation of equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.
-
Page 5: Operation
0 - 45 degrees to the right. 2. Loosen the Tilt Lock lever and turn the Tilt Adjustment Wheel to the desired direction. Use the Degree Gauge to set precise angles. Tighten the Tilt Lock lever. Page 5 SKU 45725... - Page 6 1. You should always use a miter gauge (not included) to move material through the Sander / Grinder. Miter gauges are available at Harbor Freight Tools. This tool uses a 3/4” miter gauge. Read the instructions that come with the miter gauge for miter settings and ad- justments.
-
Page 7: Maintenance
2. Clean the surface of the Sander / Grinder with a clean cloth or soft dry brush. 3. Check all nuts and bolts for tightness. Tighten if necessary. 4. Check sanding disk for tears or frays. Replace if necessary. 5. Clean debris from 3/4” miter slot. Page 7 SKU 45725... -
Page 8: Parts List
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. Page 8 SKU 45725... -
Page 9: Assembly Drawing
Assembly Drawing Page 9 SKU 45725...
Need help?
Do you have a question about the 45725 and is the answer not in the manual?
Questions and answers