Assembly; Tool Rest Assembly; Eye Shield Assembly - Central Machinery 6510 Set Up And Operating Instructions Manual

aSSemBlY

The 10" Bench Grinder requires
minor assembly. The assembly
instructions below are written for the
left side but the right side is identical.
Refer to the Parts List, at the back
of this manual, for the individual part
numbers.

tool rest assembly

1. Bolt the BENCH GRINDER UNIT (1)
to a stable workplace.
FiGure 1 – removing the tool rest knob
2. Facing the front of the BENCH
GRINDER UNIT, remove the front
TOOL REST KNOB, and loosen the
rear TOOL REST KNOB (8) as in
Figure 1.
Page 10 For technical questions, please call 1-800-444-3353.
3.
4.
tool
rest
(7)
tool rest
knob (8)
5.
1.
FiGure 2 – moving tool rest
Pivot the tool rest down and forward
so that it is in a horizontal position
and replace the front TOOL REST
KNOB as shown in Figure 2.
Adjust the TOOL REST (7) to the
desired distance from the GRINDER
WHEEL (2). In no circumstances
should the TOOL REST be clos-
er than 1/8" from the GRINDER
WHEEL.
Tighten both TOOL REST KNOBS.

eye Shield assembly

Bolts
(15)
Washers
nuts (16)
(17)
FiGure 3 –
attaching the eye Shields
and eye Supports
Attach the EYE SHIELDS (3) to
the SHIELD SUPPORTS (4) using
BOLTS (15), NUTS (16), and WASH-
ERS (17) as shown in Figure 3.
tool
rest
(7)
tool rest
knob (8)
eye
Shield
(3)
SKU 6510