Lanier LD225 Settings Manual page 133

Problem Causes
The main power in- This occurs in the fol-
dicator continues lowing cases:
blinking and does
• The exposure
not turn off when
pressed.
• The machine is
• The hard disk is
Original images are You may have load-
printed on the re- ed the paper incor-
verse side of the pa- rectly.
per.
Misfeeds occur fre- The tray's side
quently. guides may not be
locked.
The tray's end guide
may not be set prop-
erly.
You may have load-
ed paper of a size not
shown on the paper
size selector.
An error message re- When a misfeed mes-
mains, even if misfed sage appears, it re-
paper is removed. mains until you open
and close the cover,
as required.
An error message re- This may occur if the
mains, even if con- HDD is not installed.
sumables are
replaced and/or mis-
fed paper is re-
moved.
Cannot print in du- You cannot use pa-
plex mode. per in the bypass tray
for duplex printing.
[1 Sided Copy] is se-
lected for Paper
Type: Tray 1-4.
Solutions
Close the exposure glass cover or ADF, and
check if the machine communicating with a
computer.
glass cover or the
ADF is open.
communicating
with external
equipment.
active.
Load paper correctly. Load paper into Tray 1-4
with the print side up, and into the LCT or by-
pass tray with the print side down. See p.125
"Orientation-Fixed Paper or Two-Sided Paper".
Check the side guides are locked. See p.134
"Changing the Paper Size".
Check the end guide is set properly. See p.134
"Changing the Paper Size".
When using paper of a size that cannot be de-
tected automatically, use Tray Paper Settings to
set the paper size. See p.58 "Tray Paper Size:
Tray 1–4" and p.164 "Copy Paper".
Clear misfed paper, and then open and close the
front cover. See p.129 "x Clearing Misfeeds".
Press the {Start} key.
For duplex printing, select Tray 1-4 in copier
mode or with the printer driver.
Select [2 Sided Copy] for Paper Type: Tray 1-4. See
p.60 "Paper Type: Tray 1–4"
If Your Machine Does Not Operate As You Want
6
121