Table of Contents
Advertisement
7)
Sleep Mode
a) Press the On!Offkey
to turn on the remote controller.
b)
Press the Sleep key. "Sleep" will appear on the LCD display.
c)
Press either/\
of V key of the Temperature
key until the LCD displays
the desired
temperature.
d)
Press the Fan Speed keyuntil the LCD displays the desired Pan speed.
e)
Press Timer and Time Adjustment keys until the LCD displays the desired operation hours.
f) Press the Transmit key.
CONDENSATE
WATER
DRAINAGE
1)
Internal Water Tank
When operating in cooling or dehumidifying mode, the condensate water will drain into the internal
water tank. Depending o17the surrounding
humidity, the unit can continuously operate for 2 to
12 hours before the internal water tank is full. When the internal water tank gets full, the LCD
window shows error code "E4" and a beep alarm will sound eight times for 15 seconds. The
compressor stops running and the Pan will continue to mn in the set speed for three minutes before
the entire unit automatically shuts off.
When the water tank is full, take out the entire water tank slowly and discard the water inside the
tank, place it back to its original position. You will then be able to turn on the unit again.
If you want to take out the internal tank before it is full of water, please stop the unit first. Wait for
3 minutes before taking out the water tank to prevent the condensate water from discharging into
theunit.
NOTE: Do not take out the water tank when the unit is running on either cooling or dehumidifying
mode or the alarm will sound and the compressor stops. The mode will automatically change to FAN
mode and the compressor will require approximately 3 minutes to restart to the cooling/dehumidifying
cycle.
2)
Continuous
Drainage
The unit can operate on continuous drainage mode. When the unit is operating on continuous drainage
-11-
Hide quick links:
Advertisement
Table of Contents
