Poulan Pro PP125 Instruction Manual page 8

ON/OFF SWITCH
The O N/OFF switch islocated onthe trigger
handle and i sused to stop the engine. Move the
switch to the OFF p osition tostop t he e ngine.
PRIMER BULB
The PRIMER BULB removes air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulis on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
START LEVER
The START LEVER helps to supply fuel to the
engine to aid in starting. Activate the starting
system by moving the start lever to the START
position. DO NOT squeeze the throttle trigger
until the engine has started and runs, After the
engine starts, allow the engine to warm-up
10-15 seconds, then fully squeeze the throttle
trigger to deactivate the starting system.
COUPLER
The COUPLER enables optional attach-
ments to be installed on the unit.
BEFORE STARTING ENGINE
_ WARNING:
Be sure to read the fuel
information in the safety rules before you be-
gin. if you do cot understand the safety rules,
do not attempt to fuel your unit. Call
1-800-554-6723,
FUELING ENGINE
_ WARNING: Remove fuel cap slowly
when refueling.
HELPFUL TIP
To obtain the correct oil mix I
pJ ratio, pour 3.2 ounces of I
'/ 2-cycle synthetic oil into I
one gallon of fresh gas. I
This engine is certified to operate on un-
leaded gaseiine, Before operation, gasoline
must be mixed with a good quality synthetic
2-cycle air-cooled engine oil designed to be
mixed at a ratio of 40:1. Poulan/WEED EATER
brand synthetic oil is recommended, Mix gaso-
line and oil at a ratio of 40:1, A 40:1 ratio is ob-
tained by mixing 3,2 ounces (95 mt) of oil with 1
gaflon (4 liters) of unleaded gasoline. DO NOT
USE automotive oil or marine oil. These oils
will cause engine damage. When mixing fuel,
follow instructions printed on container, Once
oil is added to gasoline, shake container mo-
mentarily to assure that the fuel is thoroughly
mixed. Always read and follow the safety
rules relating to fuel before fueling your unit.
IMPORTANT
Experience indicates that alcohol blended
fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads to
separatioe and formation of acids during stor-
age, Acidic gas can damage the fuel system
of an engine while in storage. To avoid engine
problems, empty the fuel system before stor-
age for 30 days or longer, Drain the gas tank,
start the engine and let it run until the fuel lines
and carburetor are empty, Use fresh fuel next
season. Never use engine or carburetor
cleaner products in the fuel tank or permanent
damage may occur.
See the STORAGE section for additional in-
formation,
HOW TO STOP YOUR UNIT
• To stop the engine, move the ON/OFF
switch to the OFF position,
Switch
HOW TO START YOUR UNIT
_;_,WARNING:
Avoid any contact with
the muffler. A hot muffler can cause serious
burns.
Starting position
HELPFUL TIP I
!f your engine still does not I
start after following these I
instructions, pleas e call
1-800-554-6723.
STARTING A COLD ENGINE
NOTE: DO NOT squeeze the throttle trigger
until the engine has started and runs.
1. Set unit on a fiat surface,
2. Move ON/OFF switch to the ON position,
3. Slowly press the primer bulb 6 times,
4. Move the start lever to the START posi-
tion.