Remote Control Operation - Pioneer VSX-D704S Operating Instructions Manual

REMOTE CONTROL OPERATION
System Control
i PUTTING BATTERIES INTO THE REMOTE
CONTROL UNIT
[ REMOTE CONTROL RANGE 1
7m(23 feet)
1. Open the battery compartment cover on the rear of
the remote control unit. The cover should open easily
if you slide it in the direction of the arrow while
pressing on it with your thumb.
2. Press the RESET button in the battery compartment.
3. Take out the two supplied batteries size ["AA" (IEC
R6/UM-3)], and insert them into the battery
compartment in accordance with the indications in
the compartment.
4. Close the cover of the battery compartment.
Incorrect use of batteries may lead to leakage or
rupture. Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly
matching the positive (+) and negative (-) polarities, as
indicated inside the compartment.
B.
Never mix new and used batteries.
C.
Batteries of the same size may have different voltages,
depending on their type. Do not mix different types of
batteries.
When operating the remote control unit, point the front of
the unit at the front panel of the receiver. The remote control
unit may be used within a range of about 7 meters (23 feet)
from the remote sensor, within angles of up to about 30
degrees.
Performance of the remote control unit is adversely affected
in the presence of a strong fluorescent light. Keep such lights
away, especially from the sensor window.
Battery Replacement
As battery power runs down, the range over which the remote
control unit can operate decreases. Also, ONE TOUCH
OPERATION and other buttons light less brightly.
When the range becomes too short, change the batteries.
24
<ARB703b>