Pioneer VSX-D704S Operating Instructions Manual page 38

TROUBLESHOOTING
Symptom Cause
No auto stop. • Input signals are not strong enough. •
TV source cannot be seen
when the VCR's TV tuner is
used.
No rear sound is produced.
Remote control does not
work.
• TV antenna is not connected to the VCR,
or connections are faulty.
• The VCR's input switch is set to line input.
• The SURROUND MODE buttons are set
incorrectly.
• The REAR LEVEL is turned down.
• Speaker connecting wires are disconnected
from the REAR SPEAKERS terminals.
• Batteries are dead or missing in remote
control unit.
• Poor angle or too great a distance from
the remote sensor window.
• There is an obstacle between you and the
remote sensor window.
• A fluorescent light is shining on the
remote sensor window.
Remedy
(FM) If the supplied simple antenna is being
used, change to an outdoor antenna.
Consult the VCR's operating instructions, and
connect the antenna correctly.
Set the VCR's input switch to built-in tuner.
Set correctly.
Refer to page 33 and adjust the rear level.
Connect wires to the terminals securely.
Insert new batteries.
Use within 7 meters and within a 30 degree
angle of the remote sensor window.
Change your position or move the obstacle.
Move the receiver so fluorescent light does
not shine directly on the receiver's front panel
remote sensor window.
Abnormal functioning of this unit may be caused by, static electricity,
or other external interference. To restore normal operation, turn the
power off and then on again, or unplug the AC power cord and then
plug it in again.
38
<ARB7035>