Pioneer VSX-D704S Operating Instructions Manual page 12

CONNECTIONS
f IR Repeater connection 1
Connecting a supplied IR Repeater lets you also control other components with this unit's remote control.
NOTE:
To operate components
not made
by Pioneer, perform
REMOTESET UP (P.34)after
connecting an IR Repeater.
Remote control signals directed towards this unit or GUI operation signals are transmitted from the repeater as infrared signals,
enabling control of other components.
There are two kinds of infrared repeaters. Connect either or both to match the remote control requirements of different components.
MAIN-REPEATER
Use this to operate other components with this unit's remote
control or to operate using GUI on-screen indications.
Install on top of this unit as shown in the figure.
MAIN-REPEATER
[ ooo.ooo;
\
]d) Insert the REPEATER's two
pegs into the holes on the
top.
(_) Install the REPEATER laying
on its side on the top.
MINI-REPEATER
Use this when a component operates incorrectly after receiving
a signal from this unit's remote control, or when it is difficult
for a component to receive signals from the Main-Repeater.
Stick it directly on the remote control sensor window.
There are two MINI-REPEATER terminals.
If you need another Mini-Repeater, contact you nearest Pioneer
Service Center.
MINI-REPEATER
D:: ........ :o O _O
__ _
VSX-D704S
pegs are usually
inserted in the two
rear holes.
Use the two front holes
when there's another
component on top of this
preventing easy reception
of the MAIN REPEATER's
infrared signals.
NOTE:
Toprevent possible damage, be careful to avoid accidentally
connecting the MINI-REPEATER to the MAIN-REPEATER
terminals.
VCR
(_ Remove the seal.
(_) Stick onto the remote control
sensor window.
12
<ARB7035>