Remote Control Operation; Putting Batteries Into The Remote Control Unit; Remote Control Range - Pioneer VSX-454 Operating Instructions Manual

REMOTE CONTROL OPERATION
PUTTING BATTERIES INTO THE REMOTE
CONTROL UNIT
1. Open the battery compartment cover on the rear of
the remote control unit. The cover should open easily
if you slide it in the direction of the arrow while pressing
on it with your thumb.
2. Take out the two supplied batteries size (AA/R6), and
insert them into the battery compartment in
accordance with the indications in the compartment.
3. Close the cover of the battery compartment.
Incorrect use of batteries may lead to leakage or
rupture. Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly
matching the positive (+) and negative (-) polarities, as
indicated inside the compartment.
B.
Never mix new and used batteries
c.
Batteries of the same size may have different voltages,
depending on their type. Do not mix different types of
batteries.
REMOTE CONTROL RANGE _
When operating the remote control unit, point the front of
the unit at the front panel of the receiver. Tne remote contro!
unit may be used within a range of about 7 meters from the
remote sensor, within angles of up to about 30 degrees.
Performance of the remote control unit is adversely affected
in the presence of a strong fluorescent light. Keep such lights
away, especially from the sensor window.
Battery Replacement 3
As battery power runs down, the range over which the remote
control unit can operate decreases. When the range becomes
too short, change the batteries.
+ The accessory remote control unit can be used to control
some functions of other Pioneer cassette decks, CD
players, tuners, VCRs, LD players, and TVs (only those
bearing the Pioneer (i) mark ).
+ When the accessory remote control unit is used to operate
other PIONEER components with the &@} mark, it cannot
be used to operate functions which do not correspond to
the functions listed on the remote control unit.
Transmit mode selector switch
AUDIO:
Select this position for remote control operation of audio
equipment such as a CD player or a cassette deck.
VIDEO:
Select this position for remote control operation of video
equipment such as an LD player, VCR or TV.
Transmit mode selector switch
DISC SELECT avoxd
- Lt
DISC SIDE
19
<ARB7025>