Pentax K-7 Operating Manual page 34

Slr digital camera
Hide thumbs Also See for K-7:
Table of Contents

Advertisement

8
Press
the shutter
release
button
fully.
Continue to press the shutter release button until the set number of shots
has been captured.
Three or five consecutive
images will be taken according to the order set
in [8. Auto Bracketing
Order] in the [O Custom Setting 2] menu (p.85).
• When the focus mode is set to AF.S (Single mode), the focus is locked in the
first frame position and used for subsequent
continuous
frames.
• Even if you take your finger off the shutter release button during Auto
Bracket. the Auto Bracket exposure
setting will remain effective for twice as
much time as the exposure
metering timer (default
setting is approximately
20 seconds)
(p.114) and you can take a picture at the next compensation
value. In this case. auto focusing
works for each frame. After about twice as
much time as the exposure
metering
timer, the camera returns to settings for
taking the first picture.
• You can combine Auto Bracket with the built-in flash or external flash (P-TTL
auto only) to change only the flash output continuously.
However, when using
an external flash, holding
the shutter
release button down to take three
continuous
frames
may cause the second and third frames to be taken before
the flash is fully charged.
Always take one frame at a time after confirming
that charging
is complete.
• Exposure
Bracketing
is not available
when the exposure
mode is set to B
(Bulb) mode.
• Exposure
Bracketing
and Multi-exposure
cannot
be used at the same time.
The mode set last is used.
• When [7. One-Push
Bracketing]
in the [C Custom Setting 1] menu (p.85) is
set to [On], even if the shutter release button is not continuously
pressed
fully, all frames
are automatically
shot with one press of the shutter release
button.
Taking Only Overexposed
or Underexposed
Pictures
You can use Auto Bracket mode for only underexposure or
overexposure shots by combining the operation with EV
compensation (p. 115). Auto Bracket is performed in both cases on
the basis of the specified EV compensation value. (Up to +8 EV)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents